GB
Operating Instructions
05
AUTOMATIC DEFROSTING
Wood’s dehumidifiers are fitted with
a control unit which ensures that the
cooling coils are defrosted automatically
when needed. The control shuts down
the compressor, which causes the cooling
of the coils to stop. The fan continues
to draw the air at room temperature
through the dehumidifier and thus melts
the ice, and the water runs down into
the reservoir. This defrosting system
means that the dehumidifier works at
temperatures as low as +5˚C.
FAN
The fan ensures that air flows through the
dehumidifier. Moist air is sucked in from
the rear and goes via the cooling coil and
the vaporizer to come out dry and warm
at the top of the dehumidifier. Wood’s
dehumidifiers are fitted with two fan
speeds.
•
Position II – gives a high air flow with
maximum dehumidifying of air.
•
Position I – gives a lower air flow
which causes quieter operation and
somewhat lower dehumidifying
capacity.
CLEANING AND MAINTENANCE
Wood’s dehumidifiers require cleaning
of filter, to maintain their high
dehumidifying capacity.
-- The cooling coils are best cleaned with a
rag and warm water-be careful
- The fan motor is permanently lubricated
and requires no maintenance.
NOTE: Always disconnect the cord
before cleaning.
HINTS:
- Sometimes it may be useful to use a frost
guard or heater fan to make sure that the
temperature does not fall below +5˚C.
- For maximum dehumidifying power in
a room, it is recommended that the air
supply from outside and from adjoining
rooms is minimized – close doors and
ventilators.
- Put in the center of the room
- Increase temperature. for faster
dehumidification
( warm air carries more water.)
- Use frost guard if temperature falls below
+5°C
- Higher dehumidification in autumn /
summer because outside air is warm and
humid. (Absolute humidity is normally
higher).
WHEN THE DEHUMIDIFIER REQUIRES
SERVICING
If the dehumidifier requires servicing,
you must first contact the retailer. Proof
of purchase is required for all guarantee
claims.
GUARANTEES
2 year´s guarantee against faults in
manufacture. Note that the guarantee is
only valid for reciept of receipt.
NOTE!
Get a 3-years warranty!
Register at warranty-woods.
com. Please visit woods.se for more
information.
Recommended limits for use
Temp. MDK +5˚C to +35˚C
Relative humidity: 30% to 90%
Recommended
humidity level: appr. 50% RH
IMPORTANT! - Wood’s
dehumidifiers must be connected
to an grounded power source.
The power source sould be
220V-240V 50Hz
Summary of Contents for MDK21
Page 2: ......
