36
WOODS
ADJUSTMENTS
FIGURE 1
PARKING BRAKE
NOTE:
There are 2 brakes, 1 on each transaxle.
The parking brake should keep the machine from
moving. To check the parking brake, park the ma-
chine on a level surface, open the bypass valves and
set the parking brake to
ON
. Attempt to move the
machine forward and backward by pushing it. If the
machine moves, adjust the parking brake linkage as
follows:
1. Move the machine to a flat horizontal surface.
2. Grip the flats on the brake rod
A
. Tighten nut
B
on the brake rod until you run out of threads.
See Figure 1 for detailed view.
3. Move the parking brake handle to the
OFF
position.
4. Loosen nut
X
.
5. Hold brake arm in the
OFF
position as shown in
Figure 2.
6. Adjust swivel
U
until swivel stud meets brake arm
hole in the
OFF
position.
7. Insert cotter pin into swivel
U
.
8. Tighten nut
X
.
9. Repeat Steps 1-8 on the opposite side.
FIGURE 2
Summary of Contents for 872311G
