24
WOODS
OPERATION
CUTTING
1. Place the discharge chute in the down position or
correctly fit a grass collector or mulcher plate.
2. Sit in the seat.
3. Start the engine.
4. Turn the blades on by pulling up on the PTO
switch. Do not start the blades at full throttle.
Instead, use the slowest throttle setting that will al-
low the engine to pick up the blade load to reduce
the wear on the belts and electric clutch.
5. After the blades are rotating, set the throttle to
maximum. Use the traction levers to obtain the
required cutting speed, to steer around obstacles
and to turn at the end of a cut.
CUTTING TIPS
– When mowing large areas, start by turning to the
right so that clippings will be discharged away
from shrubs, fences, driveways, etc. After two or
three rounds, mow in the opposite direction, left
hand turns, until finished.
– If grass is extremely tall, it should be mowed
twice, the first cut relatively high, the second cut to
the desired height.
– Use the left side of the mower for trimming.
– Choose cutting directions so that clippings are
thrown onto areas that already have been cut.
This method results in the most even distribution
of clippings and more uniform, better appearing
cuts.
– Use a different mowing pattern each time a prop-
erty is cut where possible. This helps prevent
rutting and leads to a more uniform cut by keeping
the grass from always laying the same way.
THROWN OBJECTS
–
KEEP AREA CLEAR OF PEOPLE
AND PETS.
–
REMOVE OBJECTS BLADE MAY
STRIKE AND THROW.
–
STOP BLADES TO CROSS GRAVEL
AREAS
–
DO NOT OPERATE WITHOUT CHUTE,
MULCHER OR ENTIRE GRASS COL-
LECTOR IN PLACE.
WARNING
ROTATING BLADES
–
KEEP HANDS AND FEET AWAY.
–
STOP ENGINE AND LET BLADES STOP
BEFORE REMOVING GRASS COLLEC-
TOR OR UNCLOGGING.
DANGER