38
WOODS
Note:
Always use Woods. replacement belts, not
general purpose belts. Woods belts are specially
designed for use on commercial mowers and will
normally last longer.
ADJUSTMENTS
TRACKING HANDLES
An adjustment is provided to allow the operator to
align the control levers with each other during opera-
tion.
1. Turn knob
W
clockwise to shorten control lever
travel.
2. Turn knob
W
counter-clockwise to increase con-
trol lever travel.
DAMPERS
Different damper mounting holes have been provided
for various operator preferences with control lever
motion.
1. For a stronger resistance feel, mount the damp-
ers
X
in the outer most hole
Z
of the motion
control weldment.
2. For a lighter resistance feel, mount the dampers
X
in the inner most hole
V
of the motion control
weldment.
CUTTERDECK BELT
1. Tilt floorplate all the way forward.
2. Set the cutterdeck in a middle height-of-cut posi-
tion.
3. Use a 3/8" ratchet and extension to back
tensioning idler off to remove belt from idler.
Remove belt from cutterdeck pulleys.
NOTE:
Use the 3/8" ratchet in the square hole
A
on
the idler.
4. Remove belt from clutch pulley.
5. Install the new belt by performing these steps in
reverse order.
A
