30
Dealer Service
MAN1078 (2/6/2014)
CROSSBAR REMOVAL
1.
It is necessary to gain access to bottom side of
cutter for crossbar removal. See Blocking Method
page 19.
NOTE:
You will need to use either the puller screw
(Item 6) or a small hydraulic jack to remove the
crossbar.
2.
Refer to blade removal on page 21. Figure 6.
3.
Remove cotter pin from bottom of crossbar and
remove nut and washer.
4.
Attach a clevis (1) to each end of crossbar, using
blade pins, spacers, keyhole plates, and blade pin
clips.
5.
Position tube assembly (5) with threaded nut (4)
toward crossbar for puller screw removal or down
for hydraulic jack removal.
6.
For removal with puller screw, attach tube (5) to
each clevis with bolts (2) and nuts (3). Place pad
(4) in nut and thread puller screw (6) into nut from
bottom. Tighten until pad is solid against gearbox
shaft. For best results, strike head of puller screw
with a hammer while tightening with a wrench.
7.
For removal with a jack, attach tube to each clevis
with puller links (7), bolts (2), and nuts (3). Place
jack on tube with end of jack pressing against
gearbox shaft. Slowly apply force with jack.
NOTE:
Hydraulic jack will not operate if tipped
more than 90°. Use care to prevent bending cross-
bar during removal.
Figure 15
. Crossbar Removal
1. Crossbar puller clevis
2. 5/8 NC x 4-1/2 HHCS
3. 5/8 NC Hex nut
4. Crossbar puller pad
5. Crossbar puller tube
6. Crossbar puller screw
7. Crossbar puller link
