Assembly
35
MAN1289 (10/18/2019)
Front and Rear Chain Shielding (Figure 33)
Figure 33
. Chain Shield Assembly
1.
Install Front Center (1), Right (2), and Left (3)
Chain Shield Brackets to front frame of cutter using
carriage bolts (6) and flanged lock nuts (7).
2.
Install Rear Right (4) and Left (5) Chain Shield
Brackets to rear of cutter using carriage bolts (6)
and flanged lock nuts (7).
INSTALL DUAL TAILWHEEL - BB84.40D
ONLY (FIGURE 34)
Figure 34
. Dual Tailwheel Assembly
1.
Install Height Adjustment Bracket (1) to rear of
cutter using 5/8 NC x 1-1/2 carriage bolts (9) and 5/
8 NC flanged lock nuts (12).
2.
Slide Right Arm Weldment (3) and Left Arm
Weldment (4) over Cross Tube Weldment (2).
Orient as shown. Do not install hardware at this
time.
3.
Place Arm and Cross Tube Assembly onto rear of
deck aligning pivot tubes of arms between lugs on
deck. The center bracket on the Cross Tube (2)
should be in line with the Height Adjustment
Bracket (1).
4.
Secure pivots of Arm Weldments (3 & 4) to deck
using 5/8 NC x 4 carriage bolts (10) and 5/8 NC
flanged lock nuts (12).
5.
Clamp Arms (3 & 4) to Cross Tube (2) using 5/8
NC x 4-1/2 cap screws (11) and 5/8 NC flanged
lock nuts (12).
1. Front Chain Shield Bracket, Center
2. Front Chain Shield Bracket, Right
3. Front Chain Shield Bracket, Left
4. Rear Chain Shield Bracket, Right
5. Rear Chain Shield Bracket, Left
6. 1/2 NC x carriage bolt
7. 1/2 NC flanged lock nut
1. Height Adjustment Bracket
2. Cross Tube Weldment
3. Right Arm Weldment
4. Left Arm Weldment
5. Tailwheel Assembly
6. Chain Shield Extension Plate
7. 1/2 NC x 1-1/4 cap screw
8. 1/2 NC flange lock nut
9. 5/8 NC x 1-1/2 carriage bolt
10. 5/8 NC x 4 carriage bolt
11. 5/8 NC x 4-1/2 cap screw
12. 5/8 NC flange lock nut
13. 1-1/2 flat washer
14. 3/8 x 2 spirol pin
