36
Assembly
MAN1289 (10/18/2019)
6.
Install Tailwheel Assemblies (5) into Right (3) and
Left (4) Arms. Secure with 1-1/2 flat washer (13)
and 3/8 x 2 spirol pin (14).
7. For models with rear chain shield
: Install Chain
Shield Extension Plate (6) on top of Rear Chain
Shield Brackets and secure with 1/2 NC x 1-1/4
cap screws (7) and 1/2 NC flanged lock nuts (8).
For models with rear band
: Discard items 6, 7, &
8.
INSTALL OPTIONAL CHECK CHAINS
Check chains are used to carry the front of cutter at a
set height.
1.
Thread check chains (2) through check chain
bracket (1).
2.
Attach lower end of check chain (2) to mast plate
with bolt (5), washer (6), and nut (7).
3.
Attach keyhole brackets (1) to each side of tractor
top link bracket with bolt (3) and nut (4).
4.
Insert check chains through keyhole brackets and
set cutter height.
Figure 35
. Check Chain Installation
1. Check Chain Bracket, Lower
2. 3/8 Chain, 32-Link and Check Lug
3. 3/4 NC x 6 HHCS GR5
4. 3/4 NC hex lock nut
5. 5/8 NC x 2-1/4 HHCS GR5
6. 5/8 flat washer
7. 5/8 NC hex lock nut
