14
Operation
MAN0999 (12/4/2012)
STOPPING ENGINE
Remove key and store in a secure location to
prevent unauthorized persons from operating
equipment.
1.
Place steering handles in PARK (pivoted outward).
2.
Move throttle to 1/3 setting.
3.
Allow engine to idle for several minutes.
4.
Turn key to OFF position and remove.
MOVING DISABLED POWER UNIT
Manually move disabled power unit by following these
steps.
1.
Locate dump valve on neutral link at middle,
underneath frame.
2.
Pull up and back and down to lock in open position.
3.
Pull up and back and then forward and down to
return to operation.
Figure 3
. Left Pump Dump Valve
WEIGHT TRANSFER SYSTEM
■
When using weight transfer system, correct
counterweight must be used to maintain stability.
The weight transfer is designed to place an additional
load on the drive wheels, providing additional traction.
1.
Attach mower to power unit and set to desired
cutting height.
2.
Torque bolt on both sides to 35 lbs-in.
NOTE:
Counterweight is needed to provide adequate
stability. Optional coutnerweight kit 78727 is required
with 60" sweeper.
Counterweights are not required when power unit is
equipped with a grass catcher system.
Do not tow a trailer over 200 lbs. Do not tow a
trailer or add power unit ballast with a combined
weight over 200 lbs. Too much weight can cause
loss of traction or stability on a slope. Too much
weight will shorten the hydraulic system life. Never
tow a trailer with a grass collection system
attached to the power unit.
CAUTION
CD101
NEUTRAL LINK
WARNING
WARNING
Summary of Contents for MOW'N MACHINE FZ22K
