24
Owner Service
MAN0826 (8/31/2010)
Figure 13
. Blade Installation
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Remove belt shields and clean out all accumulated
grass, dirt and other debris.
●
Inspect machine and replace worn or damaged
parts.
●
Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Remove the remainder using a low-pressure water
spray.
1.
Be careful when spraying near scratched or
torn safety decals or near edges of decals as
water spray can peel decal off surface.
2.
Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3.
If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
●
Inspect machine and replace worn or damaged
parts.
●
Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
●
Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
1. Spindle assembly
2. Blade
3. Screw, HHCS 1/2 NC x 1-1/2
GR5
4. Nut, flange lock 1/2 NC
Summary of Contents for Turf Batwing TBW144
