Install washer and lynch pin to each
wheel axle end.
Install two wheels on wheel axle.
Install one short tube. Install one pointed
screw and tighten.
Install bent handle on short tube. Install
one pointed screw and tighten.
Install one short tube on wheel axle.
Slide wheel axle into wheels brackets.
Offset to one side.
4
1
2
3
4
5
6
Wheel / Handle Assembly
Lower Door, Second Handle Assembly
7
8
9
10
11
12
13
Position unit on back. Remove 4 shipping
screws and discard.
Position unit with air filter up.
Install one long tube, plastic bushing
faces inward. Insert one pointed screw.
Do not tighten.
Insert bent tube into long tube. Rotate
long tube to align with cabinet hole and
insert one pointed screw. Do not tighten.
Insert hand axle. Insert second long tube.
Insert two pointed screws. Tighten all
pointed screws.
Position unit upright.
Wait 30 minutes
before starting to allow compressor to
drain back.
WARNING:
Personal injury
hazard. Do not place fingers in
ring area. Ring is spring
loaded and closes with force.
!
