Page 13
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Bain Marie (Daily)
1. Descaling is recommended for health and safety purposes and to prolong the life of the unit
2. The unit MUST be descaled monthly to remove any scaling and build-up in the unit and on the elements. Element covers should be
descaled at the same time as the unit
3. To descale, a descaling solution needs to be purchased. The descaling solution should be used as per directions on the packaging
4. Remove all food and pans from the unit before descaling
5. Ensure the unit is rinsed and thoroughly cleaned after descaling
Descaling the Unit (Monthly)
1. Every day, the empty unit should be filled with clean water. A lemon slice or a few drops of lemon juice should be added daily to the
water
2. As required, adding a commercial cleaning agent that contains citric/oxalic/nitric/phosphoric and boiling for 45 minutes will help to
prolong the life of the Bain Marie. Do NOT use cleaning agents with chlorides or other harsh chemicals as this can cause corrosion
3. Do NOT fill the unit with cold water if the elements are hot
4. Water with high mineral content needs be filtered
5. When cleaning, clean the elements properly and allow to dry before switching the unit back ON
Element Protection (Daily)
Materials Required
• Stainless Cleaner
• Non Abrasive Cleaning pad
• Clean Sanitised Cloth
• Paper Towel
• Warm soapy water
• Appropriate PPE (Personal Protective Equipment)
Cleaning Schedule
• Daily cleaning is required for the Bain Marie unit and external surfaces. This will help to maintain and prolong the efficiency of your unit
• The unit must be drained and cleaned at the end of each work day
Cleaning and Maintenance
IMPORTANT
Corrosion Prevention:
This unit MUST be completely drained, cleaned and emptied DAILY.
Leaving water in the unit for an extended period while continually topping up with water,
will cause the chloride levels to increase. As the water evaporates the chlorides and other
impurities are left behind becoming concentrated.
Without daily cleaning the concentrated build up of chlorides and impurities in the water
will corrode the stainless steel of the unit.
Failure to completely drain, clean and empty the unit daily will void the warranty!
1. Isolate from the power supply
2. The unit MUST be drained before cleaning. Ensure the waste connection is left OPENED to allow sufficient drainage while cleaning
3. Remove all Dividers, Element Covers & Gastronorm Pans
4. Dividers, Element Covers & Gastronorm Pans can be cleaned in a kitchen sink with warm soapy water. Thoroughly wipe dry with a soft
cloth after cleaning, do NOT allow to air dry
5. Clean the unit and elements with warm (not hot) soapy water and a sponge. After cleaning, flush the unit with water
6. Ensure all due care is taken when cleaning the elements, as they can become damaged
7. Thoroughly wipe the unit and elements dry with a soft cloth. Do NOT let water pool in the unit, check crevices and folds