Woodson W.CFC23, Specification, Installation And Operation Manual

Page 13

Initial Start-up & Operation

Initial Start-up 

Operation

Operation

Upon setting up your equipment, refer to these instructions to adjust the thermostat control settings:

Power ON/OFF

Temperature Adjustment

To start a manual defrost�

To see the max stored temperature; in programming mode it browses the parameter codes or increases
the displayed value�
To see the min stored temperature; in programming mode it browses the parameter codes or increases
the displayed value�

To switch the instrument off, if onF = oFF�

Not Enabled�

(DEF)

KEY FUNCTIONS:

(UP)

(DOWN)

To lock and unlock the keyboard�

To enter in programming mode�

To return to the room temperature display�

KEY 

COMBINA

TIONS:

1� Push and immediately release the 

SET

 key, the display will show the Set point value;

2� Push and immediately release the 

SET

 key or wait 5 seconds to display the probe value again�

HOW TO SEE THE SET POINT:

1� Push the 

SET

 key for more than 2 seconds to change the Set point value;

2� The value of the set point will be displayed and the “˚C” or “˚F” LED starts blinking;

4� To memorise the new set point value push the 

SET

 key again or wait 10 seconds�

HOW TO CHANGE THE SET POINT:

3� To change the set point value push the      or      arrows within 10 seconds�