INSTALLATION,OPERATION & MAINTENANCE
Tel: 1300 79 1954 Web: www.stoddart.com.au Email: fse@stoddart.com.au
Due to continuous product research and development, the information contained herein is subject to change without notice
Page 13
Woodson Griddle – WGDAxx
WARNING!
The external surfaces of this unit are NOT waterproof, do NOT hose or immerse the
unit in water or allow the ingress of water into the interior of the machine or any
electrical components
CAUTION!
DO NOT spray Stainless Cleaner onto the cooking surface.
NOTE!
WGDA60 has two thermostats for individual control of the left and right elements
which corresponds to the left and right sides of the cooking plate.
Operating Instructions
Operation
This Griddle has full stainless steel construction. The grill plate is pre-greased with animal fat. It is operated by
thermostat that is located on the front of the appliance. Exact cooking times and temperatures vary for different
cooking conditions and therefore experimentation is essential. The following basic guide should be followed.
•
Turn thermostat knob to the desired setting to operate.
•
Allow time for the plate to reach the desired temperature.
•
Return thermostat knob to the “0” or “OFF” position at the end of use.
After Hours
•
The unit MUST be
switched OFF
.
Cleaning Procedure
Regular cleaning is essential to the longevity of the product and as a result the following procedures must be
undertaken daily. Before commencing the cleaning procedure, ensure that the appliance is disconnected from the
power source and has completely cooled down prior to cleaning.
Grill Plate
•
The grill plate should be kept clean at all times, free from carbon and burnt materials.
•
Clean the grill plate with a spatula or grill stone to the original appearance for faster cooking
Grease Drawer
•
Wash and thoroughly dry the grease drawer
External Surfaces
•
Clean the stainless steel and metal parts with warm (not hot) soapy water and a sponge.
•
Rinsed the stainless steel and metal parts with clean, fresh water.
•
After cleaning, thoroughly wipe the stainless steel and metal parts dry with a soft cloth. Do NOT let water
pool on the unit. Check crevices and folds.
