INSTALLATION,OPERATION & MAINTENANCE
Woodson Contact Toaster – Split Lid WGPC62
Tel: 1300 79 1954 Web: www.stoddart.com.au Email: fse@stoddart.com.au
Due to continuous product research and development, the information contained herein is subject to change without notice
Page 9
Electrical Connection
WARNING!
This machine must be installed in accordance with AS/NZS 60335.1
Information
The electrical supply shall comply with the rating plate data.
The machine is supplied with a plug and lead (10A).
Ensure that machine is connected to a power point with compatible power rating of 240 volts 10 amps.
The machine must be plugged directly into the power outlet. The use of extension leads or power boards
are not to be used.
The equipment should be earthed according to local electrical codes to prevent the possibility of electrical
shock. It requires an earthed receptacle with separate electrical lines, protected by fuses or circuit
breaker of the proper rating.
If the supply cord is damaged, it MUST be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. Power cable cannot be stretched kinked, pressed, during
normal operation, service or anytime
WARNING!
Some procedures in this manual require the power to the equipment to be turned off and
isolated. Turn the power OFF at the power point and unplug the power supply lead by the
plug body. If the power point is not readily accessible turn the equipment off at the isolation
switch or the circuit breaker in the switchboard. Attach a yellow “CAUTION-DO NOT
OPERATE” tag. This must be performed where relevant unless the procedures specify
otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
