-16-
M1102/M1103 16-Speed Drill Press
SE
T
U
P
Figure 13.
Seating arbor into chuck.
DO NOT use a steel hammer on the
drill chuck to seat the arbor into the
spindle. You will damage the chuck
and/or spindle, which may make them
unusable or unsafe.
Figure 14.
Seating arbor and chuck into
spindle.
4.
Place the drill chuck face down on a workbench. The
arbor has a short taper and a long taper. Place the
short taper into the socket in the back of the drill
chuck and tap it with a rubber or wooden mallet,
as shown in
Figure 13
. If the chuck fails to remain
secure on the arbor, repeat
Steps 1
&
2
.
5.
Raise the chuck guard.
6.
Slide the arbor into the spindle socket while slowly
rotating the drill chuck. The socket has a rectangular
pocket where the tang (or flat portion of the arbor
shown in
Figure 13
) fits into.
7.
Using only a rubber or wooden mallet, tap the chuck
and arbor assembly into the quill as shown in
Figure
14. DO NOT use a steel hammer.
Summary of Contents for SHOP FOX M1102
