Woodstock Shop Fox W1686, Owner'S Manual

-10-

Model W1686 (For Machines Mfd. Since 11/10)

EL

EC

TR

IC

A

L

Circuit.Requirements

This machine must be connected to the correct size and 

type of power supply circuit, or fire or electrical damage 

may occur. Read through this section to determine if an 

adequate power supply circuit is available. If a correct 

circuit is not available, a qualified electrician MUST install 

one before you can connect the machine to power.

A power supply circuit includes all electrical equipment 

between the breaker box or fuse panel in the building 

and the machine. The power supply circuit used for 

this machine must be sized to safely handle the full-

load current drawn from the machine for an extended 

period of time. (If this machine is connected to a circuit 

protected by fuses, use a time delay fuse marked D.)

Circuit.Requirements.for.240V

This machine can be converted to operate on a power 

supply circuit that has a verified ground and meets the 

requirements listed below. (Refer to 

Voltage Conversion 

instructions for details.)

Circuit.Type................220V/240V,.60.Hz,.Single-Phase

Circuit.Size.............................................. 15.Amps

Plug/Receptacle..................................... NEMA.6-15

Circuit.Requirements.for.120V.(Prewired)

This machine is prewired to operate on a power supply 

circuit that has a verified ground and meets the following 

requirements:

Circuit.Type................ 110V/120V,.60.Hz,.Single-Phase

Circuit.Size.............................................. 15.Amps

Plug/Receptacle..................................... NEMA.5-15

Full-Load.Current.Rating

The full-load current rating is the amperage a machine 

draws at 100% of the rated output power. On machines 

with multiple motors, this is the amperage drawn by the 

largest motor or sum of all motors and electrical devices 

that might operate at one time during normal operations.

Full-Load.Current.Rating.at.120V................... 12.Amps

Full-Load.Current.Rating.at.240V.....................6.Amps

ELECTRICAL

The machine must be properly set up 

before it is safe to operate. DO NOT 

connect this machine to the power 

source until instrtucted to do so later 

in this manual.

Incorrectly. wiring. or. grounding. this.

machine.can.cause.electrocution,.fire,.

or.machine.damage..To.reduce.this.risk,.

only.an.electrician.or.qualified.service.

personnel. should. do. any. required.

electrical.work.on.this.machine.

NOTICE 

The.circuit.requirements.listed.in.this.

manual. apply. to. a. dedicated. circuit—

where.only.one.machine.will.be.running.

at. a. time.. If. this. machine. will. be.

connected. to. a. shared. circuit. where.

multiple.machines.will.be.running.at.the.

same.time,.consult.with.an.electrician.

to. ensure. that. the. circuit. is. properly.

sized.for.safe.operation.