-21-
Model W1686 (For Machines Mfd. Since 11/10)
SE
TU
P
Test.Run
7.
Try to start the machine with the paddle
switch.
— If the machine does not start, the switch
disabling feature is working as designed.
— If the machine starts, immediately stop
it. The switch disabling feature is not
working correctly. This safety feature
must work properly before proceeding
with regular operations. Call Tech
Support for help.
Figure.19.
Removing key from paddle switch.
Check.Gearbox.Oil
It is critical that you make sure there is oil in
the gearbox before proceeding with the test
run. Remove the spindle gearbox oil fill cap and
use the dipstick to make sure the oil level is
full. When full, the oil will read on the knurled
portion of the dipstick.
Refer to
Changing
Gearbox.Oil
on
Page.31.
for
more information on gearbox lubrication, which
type of oil to use, how much to use, and where
to put it.
GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Requires 80W–90W
or Equivalent
Gear Oil.
2.
Make sure all tools used during setup are
cleared away from the machine.
3.
Connect the machine to the power source.
4.
Verify that the machine is operating
correctly by turning it
ON
.
— When operating correctly, the machine
runs smoothly with little or no vibration
or rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5.
Turn the machine
OFF
.
6.
Remove switch disabling key, as shown below.
Once the assembly is complete and you have
verified that there is oil in the machine, test run
the sander to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
If you find an unusual problem during the
test run, immediately stop the machine,
disconnect it from power, and fix the problem
BEFORE operating the machine again. The
Troubleshooting table in the
SERVICE
section of
this manual can help.
To test run the machine, do these steps:
1.
Make sure you have read the safety
instructions at the beginning of the manual
and that the machine is set up properly.
Summary of Contents for Shop Fox W1686
Page 41: ...Model W1686 For Machines Mfd Since 11 10...
Page 44: ......
