-16-
Model W1815 (Mfg. Since 10/10)
SE
TU
P
Figure 11.
Removing switch key from
paddle switch.
Once assembly is complete, test run your machine to
make sure it runs properly and is ready for regular
operation.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety
disabling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review
Troubleshooting
on
Page 27
.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine:
1.
Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is set up properly.
2.
Ensure all tools and objects used during setup are
cleared away from the machine.
3.
Connect the machine to the power source.
4.
Verify that the machine is operating correctly by
turning the machine
ON
.
—
When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
—
Investigate and correct strange or unusual noises
or vibrations before operating the machine further.
Always disconnect the machine from power when
investigating or correcting potential problems.
5.
Turn the machine
OFF
.
6.
Remove the switch disabling key (see
Figure 11
).
7.
Try to start the machine with the paddle switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop the
machine. The switch disabling feature is not
working correctly. Call Tech Support for help.
Test Run
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.
Summary of Contents for SHOP FOX W1815
Page 33: ...Model W1815 Mfg Since 10 10...
