Parameters
A star symbol in front of the changed parameters indicates that the alterations
have only temporarily been saved. They are not yet finally stored and adopted by
the software/device.
In order to make things easier to follow, especially where complex parameter
changes are involved, on every superior/higher menu level, the intended change
of the parameter is indicated by the star symbol (star trace). This makes it
possible to control or follow from the main menu level at any time where
parameter changes have been made and have not finally been saved.
Plausibility check: In order to prevent obvious wrong settings the software
monitors constantly all temporarily saved parameter changes. If it detects an
implausibility, this is indicated by a question mark in front of the respective
parameter.
In order to make things easier to follow, especially where complex parameter
changes are involved, on every superior/higher menu level above of the
temporarily saved parameters, an implausibility is indicated by a question mark
(plausibility trace). This makes it possible to control or follow from the main menu
level at any time where implausibilities exist.
So it is possible to see from each point of the menu tree that implausibilities have
been detected by the software.
A star/parameter change indication is always overwritten by the question
mark/implausibility symbol.
If the software detects an implausibility it rejects saving and adopting of the
parameters.
Example: If the residual voltage has been parameterized as calculated (
»EVTcon
= calculated«
), then the software recognizes an implausibility in case voltage
measuring is parameterized as »phase to phase« (
»VTcon = Phase to Phase«
).
The calculation of the residual voltage is physically not possible by means of
phase-to-phase voltages.
•
Additional parameters can be changed if required.
•
In order to transfer changed parameters into the device, please select »Transfer all parameters into the
device« in menu »Device«.
•
Confirm the safety inquiry »Shall The Parameters Be Overwritten?«.
•
Enter the password for setting parameters in the popup window.
•
Confirm the inquiry »Shall The Data Be Saved Locally?« with »Yes« (recommended). Select a suitable
storing location on your hard disk.
•
Confirm the chosen storing location by clicking »Save«.
•
The changed parameter data is now saved in the data file chosen by you. Thereafter the changed data is
transferred to the device and adopted. .
Once you have entered the parameter setting password, Smart view wont
ask you again for the password for at least 10 minutes. This time interval
will start again, each time parameters are transmitted into the device. If for
more than 10 minutes no parameters are transmitted into the device, Smart
view will ask you again for the password, when you are trying to transmit
parameters into the device.
Page 204
EN MRU4 10/09
