Manual 37442B
LSG - Load Share Gateway
© Woodward
Page 9/32
Chapter 2.
Installation
Safety Precautions
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
WARNING
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
•
Only qualified workers should install this equipment. Such work should be performed only after read-
ing this entire set of instructions.
•
NEVER work alone.
•
Before performing visual inspections, tests, or maintenance on this equipment, disconnect all
sources of electric power. Assume that all circuits are live until they have been completely de-
energized, tested, and tagged. Pay particular attention to the design of the power system. Consider all
sources of power, including the possibility of backfeeding.
•
Apply appropriate personal protective equipment and follow safe electrical practices.
•
Turn off all power supplying the equipment in which the LSG is to be installed before installing and
wiring the LSG.
•
Always use a properly rated voltage sensing device to confirm that power is off.
•
Beware of potential hazards, wear personal protective equipment, and carefully inspect the work area
for tools and objects that may have been left inside the equipment.
•
The successful operation of this equipment depends upon proper handling, installation, and opera-
tion. Neglecting fundamental installation requirements may lead to personal injury as well as damage
to electrical equipment or other property.
Failure to follow these instructions will result in death or serious injury!
WARNING
No dead bus closure interlock between easYgen and legacy products is provided by the LSG. A clo-
sure of the easYgen or legacy product onto a dead busbar simultaneously with other controls must be
prevented by external means!
The unit does not provide any protection and in addition renders the built-in protection of the easYgen
dysfunctional!
Regulatory Notes
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
•
The LSG is suitable for use in non-hazardous locations only.
•
The LSG is not authorized for use in life support devices or systems.
•
Wiring and installation must be in accordance with applicable electrical codes in accordance with the author-
ity having jurisdiction.
•
The LSG is designed for installation into an electrical switchboard or cubical as part of a fixed installation.
