24 | UM-BS-EN-A3
6
Setup & Installation
6.1
General
Ensure that the conditions applicable to basic safety and health requirements are met.
Read these operating instructions completely before installation.
Before installing the device, operational and functional safety are to be tested, including correct
installation, electrical connection, and operator instruction.
In most cases, your WOODWAY BOOST will be delivered completely assembled. Check immediately
upon delivery for any signs of transportation damage and immediately report any damages to the
transport company and WOODWAY.
Position the BOOST to ensure that the power cord can easily be accessed and disconnected when
needed. Make sure it is not bent or angled such that it could disconnect.
ATTENTION
Installing after Storage or Transport
The formation of condensation on the cooled electronic parts may cause the BOOST to
malfunction and damage the electronics.
►
Before installing after storage or transport, the BOOST must stand at room temperature
for approx. 3 hours to become acclimatized.
WARNING
Do not modify the Device
Do not modify this equipment without authorization of the manufacturer.
6.2
Installation
It is recommended that transport, installation, and assembly of the BOOST are carried out by
WOODWAY or by an authorized dealer or service provider. Otherwise, shipping damage or improper
installation and assembly of the BOOST could cause a hazard when using the device.
ATTENTION
Prepare a Stable Surface
Before the device is installed, the surface must be prepared. The total weight
of the device (with all the accessories and options) is to be considered.
►
Prepare a stable and sturdy surface.
►
Only install the device on a level, stable, and sufficiently sturdy surface.
If necessary, install an additional base plate/floorboard.
