MK1 PRO - User Manual
35
ENG
2.4.7 - Speed-bar adjustment and release
The MK1 PRO is equipped with a two-step speed-bar. We suggest that you
only secure the speed-bar after you have found the optimal seating adjust-
ment. First, make a loop of a couple of centimetres at the ends of the cord
that goes up from the speed bar (to be clearer, the one that goes through
the sheaves).
Then tie the two black release cords with the straight metal pin and rubber
O-ring (supplied) to the black loops at the junction between the load-bear-
ing strap and the chest strap, near the 3-ring.
Take care not to attach the release cord to the white release loop of the
3-ring, near the black loop.
The length of the release cord must be equal to the distance between the
speed hook on the riser and the 3-ring system. Basically, once the cord is
attached, the straight pin and the hook must be at the same height.
CAUTION
The release cord with the pin must be about 1.5 cm shorter than the loop
made at the end of the speed loop. To do this it is important to check and if
necessary shorten the cord by moving the knot on the black loop.
Proceed by threading the loop of the speed cod first inside the O-ring and
then inside the hook on the riser. Once this is done insert the straight pin
inside the loop of the speed loop coming out of the hook, then insert the
O-ring into the hook and lastly pass the straight pin inside the O-ring.
To shorten or lengthen the speed cord, and therefore to adjust it, simply
move the loop further forwards or backwards, taking care to also check the
release cord.
Summary of Contents for MK1 pro
Page 1: ......
Page 2: ......
Page 11: ...MK1 PRO User Manual 10 ENG ...
Page 49: ...MK1 PRO User Manual 48 ENG 8 APPROVAL CERTIFICATES 9 WARNING LABEL ...