http://www.woosim.com
34
[Description]
Set the distance from the beginning of the line to the position at which
subsequent characters are to be printed.
[Notes]
1) The distance from the beginning of the line to the print position is
[(nL + nH * 256) * (vertical or horizontal motion unit)] inches.
2) Setting outside the specified printable area are ignored.
3) The horizontal and vertical motion unit are specified by GS P.
4) The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of he minimum horizontal movement
amount.
5) In standard mode, the horizontal motion unit (x) is used.
6) In page mode, horizontal or vertical motion unit differs depending on the
starting position of the printable area as follows;
1.
When the starting position is set to the upper left or lower right
of the printable area using ESC T, the horizontal motion unit (x) is
used.
2.
When the starting position is set to the upper right or lower left of the
printable area using ESC T, the vertical motion unit (y) is used.
[Reference]
ESC\, GS$, GS\, GS P
ESC \ nL nH
[Name]
Set relative print position
[Format]
ASCII
ESC
\
nL
nH
HEX
1B
5C
nL
nH
Decimal 27
92
nL
nH
[Range]
0 ≤ nL ≤ 255,
0 ≤ nH ≤ 255
[Description]
Set the print starting position based on the current position by using
[Notes]
1) This command sets the distance from the current position to
[(nL + nH * 256) * horizontal or vertical motion unit]
2) Any setting that exceeds the printable are is ignored
Summary of Contents for WSP-BT30
