WSP-i250 Rev. 1.0
http://www.woosim.com
17
2
2
.
.
6
6
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
In keeping on pressing the Feed and Power button simultaneously until after the
ERROR
lamp
blinks 5 times, the printer comes out at the circumstance to change the printer mode
.
(refer Table 2)
l
FEED button
: changing Printer MODE status.
l
POWER button
: changing OPTION status.
[Example] The defaults of the printer are :
UART / 9600 bps / 8 data bit / No parity /1 stop bit / Density low /
Quality low / Mark use / Sensor low / Power down 5 minute
If a user wants to modify the defaults with
Bluetooth / 57,600 bps / 7 data bit / Odd parity /2 stop bit / Density high /
Quality high/ Mark Gap/Hole / Sensor Auto / Power down no use
u
Press MODE & POWER Button during the
Error Lamp
flickers 5 times.
→
You will see present
COMMUNICATION
mode in the LCD. (UART)
→
Press the
POWER Button
twice. And then, interface mode has set to
Bluetooth
mode.
u
When you press
FEED button
once.
→
You will see present
BAUD RATE
mode in the LCD. (9600 bps)
→
Press
POWER Button
3 times. And then,
BAUD RATE
has set to
57,600 bps
.
u
When you press
FEED button
once.
→
You will see present
DATA BIT
mode in the LCD. (8 Data bit)
→
Press
POWER Button
once. And then Data Bit has set to
7 DATA BIT
.
u
When you press
FEED button
once.
→
You will see present
PARITY
mode in the LCD.
(No parity)
→
Press
POWER Button
once. And then the Parity bit has set to
ODD Parity Bit.
.
u
When you press
FEED button
once.
→
You will see present
STOP BIT
mode in the LCD.
(1 stop bit)
→
Press
POWER Button
once. And then the density has set to
2 Stop bit
.
