WSP-i450 Rev. 4.0
http://www.woosim.com
17
2
2
.
.
6
6
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
In keeping on pressing the Feed and Power button simultaneously until after the
ERROR
lamp
blinks 5 times, the printer comes out at the circumstance to change the printer mode
.
(refer Table 2)
l
FEED button
: changing Printer MODE status.
(
Power Lamp
)
l
POWER button
: changing OPTION status.
(
Error Lamp
)
[Example] The defaults of the printer are :
UART / 9600 bps / 8 data bit / No parity /1 stop bit / Density low /
Quality low / Mark use / Sensor High / Power down 5 minute
If a user wants to modify the defaults with
Bluetooth / 57,600 bps / 7 data bit / Odd parity /2 stop bit / Density high /
Quality high/ Mark Gap/Hole / Sensor Auto / Power down no use
** Only the printer which support iOS Bluetooth interface comes out at the circumstance to
change the printer mode. (Bluetooth Mode or Boluetooth(iAP) Mode).
** Manipulation methods
:
1. Press Feed and Power buttons simultaneously until the
ERROR lamp
blinks 5 times
and then keep pressing two buttons for 2 Seconds.
2. After the printer beeps twice, the Bluetooth mode is changed
and it will print the result of change.
3. The changed mode can be checked in the printout.
Example ) If the printer is in Bluetooth Mode -> Bluetooth(iAP) Mode
If the printer is in Bluetooth(iAP) Mode -> Bluetooth Mode
