EN
Risk of damage!
Operating the compressor with long feed lines, extension cords or cable drums could cause a voltage drop
and prevent the motor from starting.
− If possible, do not use any long lines, extensions or cable drums.
− An undersized air pressure system can affect the efficiency of your device.
Risk of damage!
The compressor will vibrate during operation. If you set up the compressor in an unsuitable location, you
could damage it.
− Place the compressor on an easily accessible, level, dry and sufficiently stable work surface. Do not place
the compressor on the edge of the work surface.
− During opera on, always place the compressor on the rubber feet or set it on the underside.
− Do not place the compressor on or near hot surfaces.
− Set the compressor up in a location with dry and clean air. Do not use it in wet rooms and in areas where
work is performed with spraying water or in the rain.
Connecting the pneumatic gun
Before operating the compressor, you must attach
the pneumatic gun with the manometer and, if
necessary, an adapter nozzle. To do so, proceed as
follows:
1. Make sure that the compressor has been
switched off.
2. Insert the compressed air connector plug (14) of
the pneumatic gun (15) in the quick coupling (3)
until it audibly locks into place (see fig. B). The sleeve of the quick coupling will automatically spring forward.
Disconnecting the pneumatic gun
1. Make sure that the compressor has been switched off.
2. Pull the sleeve on the quick coupling (3) of the compressed air hose (2) back.
3. Pull the pneumatic gun (15) off.
Switching the compressor on and off
1. Place or lay the compressor on a suitable work surface.
2. Make sure that the On/Off switch (1) is set to the “0” position.
3. Connect the pneumatic gun (15) and any other accessories to the compressor.
4. Insert the mains plug in a socket.
5. To switch the compressor on, set the On/Off switch to the “1” position.
6. To vent the air, push the drain valve (16) on the pneumatic gun and check the pressure on the manometer.
7. Set the On/Off switch to the “0” position to switch the compressor off.
8. If you no longer wish to use the compressor, pull the mains plug out of the socket.
9. Use the pneumatic gun to bleed the compressor; push the drain valve for this.
10. Disconnect the pneumatic gun from the compressor.
11. Let the compressor cool off completely.
12. Clean the compressor.
