•
Use cutting oil to keep the blade cool, increase cutting action, and prolong the life of the blade.
•
Do not twist or bend the saw blade.
•
Do not force the saw blade. Let it cut at its own speed.
DANGER:
a)
Always clamp the workpiece in a vice, or to a workbench or table. Do not hold workpiece in your hand.
b)
Never use gasoline as a lubricant or as a cleaning agent. A spark from the motor may cause an
explosion. Gasoline will also damage the plastic components of the saw.
GENERAL
WARNING: When servicing, use only identical replacement parts. The use of any other part may create
a hazard or cause product damage.
DO NOT use solvents when cleaning plastic parts. Plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use a clean cloth to remove dirt, dust, oil, grease etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-based products, penetrating oils, etc. to come
into contact with plastic parts. They contain chemicals that can damage, weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices can damage the tool and the workpiece.
WARNING: DO NOT attempt to modify tools or create accessories. Any such alteration or modification is
misuse and could result in a hazardous condition leading to possible serious injury. It will also void the
warranty.
It has been found that electric tools are subjected to accelerated wear and possible premature failure when
they are used on fiberglass boats and sports cars, wallboard, spackling compounds or plaster. The chips and
grindings from these materials are highly abrasive to electric tool parts such as bearings, brushes,
commutators, etc. Consequently, it is not recommended that this tool be used for extended work on any
fiberglass material, wallboard, spackling compounds or plaster. During any use on these materials it is
extremely important that the tool is cleaned frequently by blowing it out with an air jet.
WARNING: Always wear safety goggles or safety glasses with side shields during all cutting operations. It
is critical that you also wear safety goggles or safety glasses with side shields and a dust mask while
blowing dust out of the reciprocating saw with an air jet. Failure to take these safety precautions could
result in permanent eye or lung damage.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high-grade lubricant for the life of the
unit under normal conditions. Therefore, no further lubrication is required.
MAINTENANCE
!
!
!
!
!
Summary of Contents for RS07-115
Page 35: ...EXPLODED VIEW ...
Page 46: ...EXPLODED VIEW ...
