MAINTENANCE
RISK OF
INJURY!
Do not clean the blades when the engine is running. Before carrying out any inspection or
maintenance work, switch off and unplug the appliance and secure it against
unintentional switching on. Perform only the maintenance work described here. Improper
work may result in damage to the machine and thus injuries.
RISK OF
INJURY!
During use and immediately after use, the blades and gearbox may be hot! Wear gloves
when performing maintenance work.
RISK OF
MACHINE
DAMAGE!
Never clean the machine with water jet or high
-
pressure washer.
Clean the machine after each use. Inadequate cleaning can damage the machine or
reduce its performance.
Wipe the machine with a slightly damp cloth.
-
Perform a visual check of the device's function before each use. Also check all connections for strength
and tighten if necessary.
-
In the event of damage or wear to a component, replace it for your own safety. Worn or damaged parts of
the machine may only be replaced by an authorized service center or by a seller.
-
Use a stiff brush or a damp cloth to remove soil and dirt from the transmission and the blades.
-
Clean the air vents on the engine cover and remove any grass residues and impurities.
-
Immediately after cleaning the tiller blades and the drive shaft wipe dry and apply a thin layer of oil to
prevent corrosion.
-
Make sure to use genuine Worcraft replacement parts.
-
Lubricant was poured into the gearbox during production.
During the first year of use, it is not necessary to check the
lubricant content or recommend the addition of lubricant.
After the year of use, follow the instructions below:
-
The drain screw is located on the right side of the
transmission cover. Before removing the drain plugs, place
the cultivator on its left side and clean all dirt. If necessary,
remove the blades for better access to the stopper screw.
Use a suitable wrench to loosen the plugs. Add
approximately 70 ml of grease. Do not overfill. When
finished, reinstall the drain plug to the transmission.
STORAGE AND TRANSPORT
RISK OF INJURY!
Before storing, turn off the device, unplug the power plug, and secure it against
unintentional power up.
RISK OF INJURY!
Store the machine so that unauthorized persons cannot operate it. Make sure that
the storage machine cannot injure anyone.
RISK OF MACHINE
DAMAGE!
Do not store an unprotected machine in a humid environment.
Clean the machine before storing.
Store in a dry, well
-
ventilated place.
When transporting, use the original packaging if possible.
