RISK OF
INJURY!
Do not connect the electric tiller to the power supply until fully assembled. Failure to
observe this precaution could result in accidental power-on and possible serious injury.
OPERATION
- Before each use, check that the extension cord is not showing signs of damage or aging and is strong enough
to carry the power required to power the device. An undersized extension cable will cause a drop-in supply
voltage, resulting in a drop-in power and overheating. The total length of the supply cables must not exceed
40 meters, as exceeding this distance leads to a reduction in the electric motor output. The power cable must
have a cross section of 3 x 1.5 mm
2
. Replace the extension cord if it is cracked, frayed, or otherwise damaged.
A damaged power cord may only be replaced by the manufacturer or an authorized service center. If you
connect the cultivator to a power source with a damaged power cord or extension cord, and then touch the
point where the insulation is damaged before the cultivator is disconnected from the power source, you run
the risk of electric shock.
- Check the condition of the tilling blades and ensure that all threaded connections are securely tightened. If
the blades are blunt or grind replace them. If necessary, contact an authorized service center.
SWITCH ON
Note!
Before turning on the tiller, make sure that the blades are not touching any objects and that they can
move freely. Hold the machine firmly with both hands. Never work with the tiller with one hand.
- Keep the hands and feet away from the tilling blades.
1. Insert the plug into the extension cable connector.
2. Connect the other end of the extension cord to a power source.
3. Firmly grasp the electric tiller with both hands on the handles. Press the lock button (13) and
simultaneously press and hold the trigger (12). Release the lock button (13).
SWITCH OFF
1. Turn off the machine by releasing the trigger (12).
RISK OF
INJURY!
The blades will rotate for a few minutes after the machine is turned off. Never touch the
rotating blades.
- Never leave the electric tiller unattended on the work surface. Always leave the machine in a safe place and
disconnect it from the power supply when interrupting work.
USEFUL ADVICES
RISK OF
INJURY!
Before starting work, examine the terrain and remove any objects that could be thrown
by the machine.
RISK OF
INJURY!
Get acquainted with the surroundings and pay attention to the possible risks that you
may overhear due to machine noise.
RISK OF
INJURY!
Do not release the handles while working.
