The CURRENT STATUS section shows the information of the device, its IP, MAC address and
firmware version. If you want to assig a static IP to your BLS 2M, you must to unmark the "Enable
Automatic IP" option.
In the NETWORK SETTINGS section it is possible to assig a static IP to the device and to set the
subnet mask. By default all BLS 2 M has the same device name (bls_2m), if you want to log in to t
he device through web server, you need to type this name :
bls_2m.local/
If you modify the name of the device, the address in the web browser will change. For example, if
you change the field "Device name" to "emisor 1", you need to type: emisor1.local/. Take into
account that if the new name has not numbers or words, you must replace them by this
character "_".
Is recommended to set the devices separately before to connect them, on the contrary, in
installation with grat complexity, could be difficult to log in via web server. Remember, in the
installation only can be connected one BLS 2 M.
In the BLUELINE CONFIGURATION section, you can set the streaming channel assignation
mode:
Potentiometer: The channel selection is made trough the rotary source selector in the
front side. In this mode, only you can select one channel between the 16 first
of them.
Source (from 1 to 99). Enter the number of channel from you want to streaming. It is possible
to select the channel between 1 to 99.
In "Format", it is possible to select the codification mode:
Once made the adjustments, you need to store them. Press "Save settings" button
USER MANUAL
13