PAGE 5
User Manual
/ Manual de uso
High-impedance (70V/100V line) (100W x 1 channel)
Low-impedance (2x 50W @
)
8
Ω
2. Set the speaker output to high-impedance by setting the DIP Switch number 10
(14)
, according
to loudspeakers value
[
100V] or [70V] corresponding to the maximum output voltage.
3. Use speaker cables to connect the [SPEAKERS A]
terminal to the positive “+”
terminals
2. Use speaker cables to connect the
3. Use speaker cables to connect the
[SPEAKERS A] ,
terminals to the +, -
[SPEAKERS B] ,
terminals to the +, -
of the speakers, and the [SPEAKERS B]
terminals of the loaded speakers,
terminals of the loaded speakers,
terminal to the negative “-”
terminals.
In case of high-impedance connection, terminals MUST NOT BE CONNECTED
Note
:The speaker output is processed through a high pass filter (80Hz, 18dB/oct.).
Note
:Take into account the maximum power loaded per channel
(50W @ 8
Ω)
Maximum
output
voltage
:
100V
Maximum
output
voltage
:
70V
8
8
100W @ 70V or 100V
DIP switch body
1. Select 70V/100V position using the switch
(15)
.
1. Select 8
position using the switch
(15)
.
Ω/16Ω
50W @ 8
Ω
50W @ 8
Ω
Note: In low impedance DOES NOT EXIST Bridge mode. Therefore, the
usual bridge connection (using both + terminals), are used ONLY in high
impedance mode.
Note: Before operates the unit in this mode, please, check the switch (15)
position (70/100V position)
EN
SPEAKERS
SETUP
SPEAKERS
SETUP
PA 100 MX
