CAUTION
CAUTION
After to use it, please make sure to switch off the main power to avoid battery damages.
Take the battery out if you are not going to use it for a period of time.
2. This unit incorporates low voltage circuit protection for the built-in battery to avoid damages in case of incorrect
operation. When the main receiver is being used, if the voltage of the battery is less than 9 +/- 0.5 V, it will switch
off its power automatically by its low voltage circuit protection and need to be used with AC power in order to
recharge the battery.
CAUTION
CAUTION
Be sure to switch off the system main power after use, otherwise the battery will be over discharged
and it can damage the rechargeable battery, shorting the battery life.
If the LED flash up, it shows the battery is good to use. If LED is on, it shows the battery is low, you
have to change the battery before to use the system. If the LED does not flash and not on, the battery
is empty or polarity is wrong.
OPERATION WITH LAVALIER MICROPHONE
1. Open the battery compartment by sliding up the cover.
2. Put the battery into the compartment with correct polarity and close the cover.
3. Plug the Lavalier microphone jack on the transmitter.
4. Switch on the power of the transmitter and when the LED lits, it is ready to work.
5. Be careful to adjust the main control of the transmitter, start from least volume and slowly turn it to an
appropriate level to hear your voice clearly.
6. After use, you have to take the battery out of the transmitter to avoid battery leaking to damage the transmitter.
OPERATION WITH HANDHELD MICROPHONE
1. Open the battery cover.
2. Put the battery into the compartment and make sure you have a right polarity before you use it.
3. Turn the switch to ON , now you can use the microphone.
Cover
Cover
Volume
Power LED
Power Switch
MIC port
9V battery
chamber
Page 5
User Manual WAP 650
EN
