5
Handlebar Assembly
Install the stem of the handle bars into the fork tube, in a position parallel to the front wheel. Tighten
the stem bolt by using a wrench. Make sure the stem is installed below the maximum height mark.
(c) Fork tube
(d) Tighten the stem bolt
Hand Brakes Assembly and Adjustment
WARNING:
The hand brakes on this scooter were not adjusted at the factory. Before you ride the
scooter you must assemble and adjust the hand brakes. Install brake levers onto the handlebar. The
brake lever on the right hand side connects to the front brake, and the brake lever on the left hand
side connects the rear brake.
1. Squeeze the rear brake arms with your hand until the brake pads are up against the wheel
rim. This will enable the inner brake cable wire to tighten and
you’ll have enough space to
easily slip the barrel end of the brake cable wire into the hole in the brake lever.
2. Insert the brake cable wire into the slot in the front of the brake lever and then remove your
hand. The brake cable cap will automatically spring back into the slot on the front of the brake
lever assemble.
