19
Adjust the direction of rotation
You can charge the rotational direction with the right/ left rotation switch. This is not
possible if the On/Off switch is pressed.
Clockwise rotation: To drill and screw in screws press the clockwise/anticlockwise
rotation reversing switch to the left as far as it goes.
Counter-clockwise rotation: To detach or unscrew screws press the clockwise/
anticlockwise rotation reversing switch to the right as far as it goes.
Torque setting
The cordless screwdriver is equipped with a mechanical torque setting (2).
You can preselect the required torgue in 22 levels with the torque setting (2). If set
correctly the operational tool is stopped as soon as the screw is screwed flush into the
material or the set torque level has been reached.
Potentially select a higher setting to unscrew screws or set it to the drilling symbol.
Mechanical gear selection
The gear selection switch (4) enables you to work with a higher or lower speed of rotation.
To avoid any damage to the gears, the gear selection should only be operated when the
drill/driver is at a standstill.
Gear 1: intended for screws or for work involving a large drill diameter.
Gear 2: intended for work with a small drill diameter.
ON/OFF switch
You can control the rotational speed progressively with the on/off switch (6). The stron-
ger you press the switch, the higher the rotational speed of the cordless screwdriver.
To switch off the power tool, let go of the ON/ OFF switch (6).
Tool changes
Attention! Place the clockwise/anticlockwise rotation reversing switch (5) in the centre
position during all work (e.g. tool change, servicing etc.).
• The cordless screwdriver is equipped with a keyless drill chuck (1) with an automatic
locking device.
• Screw the drill chuck (1) upwards. The drill chuck opening must be large enough to
accommodate the tool (drill or screwdriver bit).
• Select the appropriate tool. Slide the tool into the drill chuck opening as far as possible.
• Fasten the drill chuck (1) and following this make sure that it is seated tightly.
Service and care
Attention! Pull the mains plug before all cleaning work.
• Don‘t use solvents of any kind to clean the plastic parts. Different chemicals can attack
and damage these parts.
• Only use a clean cloth to remove dirt, oil, grease, dust etc.
1252650_BDA 12 V LI.indd 19
1252650_BDA 12 V LI.indd 19
28.01.21 11:43
28.01.21 11:43
