19
Wait to exchange the miller until the machine is at a complete standstill and the
miller has cooled off.
fig. 2
1
2
Mounting and setting the parallel stop (fig. 3)
The parallel stop is a device to help with the milling of narrow workpieces.
• Assemble the parallel stop. Fasten the guiding rods (2) to the frame (3) with the help
of the screws (1).
• Loosen the clamp screws (4) and slide the guiding rods into the holders (5).
• Adjust the parallel guide to the desired guide distance.
• Tighten the clamp screws again.
fig. 3
1
2
3
4 5
4
5
1192734_BDA_WB_1200 OF.indd 19
1192734_BDA_WB_1200 OF.indd 19
28.12.20 09:13
28.12.20 09:13
