Assembly
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
7
Step 1: Leveling the dryer and installing the legs.
Tools needed:
9/16” Socket
Wrench
9/16” Wrench
Parts needed:
Dryer Base
8 x Lock Washers
1. Install a hex bolt into the “J” located on the leg,
which is on the pre-assembled base.
2. Thread a lock nut onto the other side of the bolt,
which is located inside of the dryer. Make sure the nut
is very loose, because the bolt has to be able to move
when the base is lifted.
Repeat steps 1-2 for the other leg on the same side.
3. Using two people, lift the dryer to expose the leg.
The bolt will fall to the very bottom of the “J” where a
third person will tighten it. Use a 9/16” socket wrench
on the bolt and a 9/16” wrench on the nut.
The two people holding the dryer will continue holding
the same side up, so the third person can repeat steps
1 and 2 for the other leg on the same side.
8 x Flat Washers
12 x Hex Bolts (
5/16-
18” x 3/4”)
12 x Flange Nuts
