PH: 866.476.9217
11
IX. PARTS INSPECTION
When the
GO-A8-PW
Opener is in-for-maintenance and the Rolling Cart and Impactor
have been disassembled (partial or complete), the components should be cleaned and
inspected for wear before lubricating and reassembly of the Opener. Proper
maintenance of equipment often depends upon the ability of a service technician to
determine whether a part or assembly is worn to the point where it should be replaced.
The following information is intended to help the service technician make this decision.
Rebuild Kit (PN: 32-50010)
Repair Kit (PN: 32-50020)
Item
#
Part #
Description
Qty
Item
#
Part #
Description
Qty
28
33-20121
Rotor Blade
9
28
33-20121
Rotor Blade
9
7
33-20136
Front Gasket
2
7
33-20136
Front Gasket
2
32
33-20135
Rear Gasket
1
32
33-20135
Rear Gasket
1
25
33-20154 Cylinder Plate Bearing
2
18
33-20155
Anvil Cone Bearing
1
n/a
33-10605
Grease
2
1.
The
CYLINDER [29]
is a sleeve that has been hardened, ground and honed
to close tolerance. It includes a series of slots or holes in the wall for porting
the air to the Blades, and exhausting it to atmosphere. Examine the Cylinder
on the inside diameter for rough circular grooves. If such grooves are in
excess of .005” deep, replace the Cylinder. Such grooves are usually caused
by foreign matter in the airline.
IMPORTANT
The components should be cleaned and
inspected for wear or damage before
lubricating and reassembly of the Opener.
Summary of Contents for GO-A8-PW
Page 1: ...GO A8 PW Gate Opener MAINTENANCE PARTS MANUAL...
Page 22: ...PH 866 476 9217 18 XI IMPACTOR EXPLODED VIEW...
Page 31: ...NOTES...
