19
SPECIFICATIONS
ENGLISH
The nailer shoots 23 gauge pin nails. It can be used for cabinet making
and furniture assembly, door soffit work, trim and moulding application,
picture framing and applications where gluing is necessary, but clamping
is impractical.
Shoots industry standard 23 gauge pin nails in the following sizes:
15/32” (12 mm), 19/32” (15 mm), 23/32” (18 mm), 3/4” (20 mm),
7/8”(22 mm),1"(25 mm)
Operating pressure: 70-110 PSI
Air consumption: 4-5 CFM @ 90 PSI
Air inlet: 1/4” NPT
Rubber grip
ACCESSORIES
3 hex keys
Small bottle of air tool oil
Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 120 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air resource:
a) Before making adjustments.
b) When servicing the tool.
c) When clearing a jam.
d) When tool is not in use.
e) When moving to a different work area, as accidental actuation may occur,
causing injury.
Never connect tool to an air source that may exceed 180 PSI. Over
pressurizing the tool may result in bursting, abnormal operation, breakage of the
tool or serious injury to persons. Use only clean, dry, regulated compressed air
at the rated pressure or within the rated pressure range as marked on the tool.
Always verify prior to using the tool that the air source has been adjusted to the
rated air pressure or within the rated air-pressure range.
IMPORTANT SAFETY INSTRUCTIONS
