9. ADMINISTRATOR MODE
9.3 Radiometry
In this part, you can set:
Camera emissivity,
Atmospheric temperature,
Reflected temperature,
Camera temperature range,
Synchronous image correction limit.
Figure 9.7: Radiometry settings.
9.4 Modes
In this part, you can set input triggers and modes for controlling the measurement. You can select one of the
four measurement modes:
Frame Measurement and Evaluation,
Start‐Stop Measurement and Evaluation,
Continuous Evaluation,
Non‐Trigger Evaluation.
For each triggered mode, you can select one of the two trigger options:
1.
Latch trigger
‐ One trigger signal, measurement during high level of the signal.
2.
Start and Stop
‐ Two trigger signals ‐ one for starting and one for stopping the measurement.
(a) Latch trigger.
(b) Start‐Stop trigger.
Figure 9.8: SMARTIS trigger options ‐ Latch or Start‐Stop triggers.
For each trigger signal, you can select the steady‐state and ON‐state logical level to either:
E‐mail and Web
info@workswell.eu
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
Libocka 653/51b
Prague, Czech Republic
Version 210127 EN, 27
th
Jan, 2021
All pictures are only for illustration.
Real values may vary.
23
