Air Compressor
AFTER SALES SUPPORT
(toll free)
MODEL No.: PAP110 • 02/2019 63569
e-mail: info.aldi@positecgroup.com
AUS
8
1300 889 028
AUS
Connecting adapters to the valve adapter / connector
WARNING:
Ensure the air compressor is switched off and
disconnected from the mains power supply before undertaking
any assembly.
1. Choose the adapter required for the task to be undertaken.
2. To connect an adapter to the hose with valve adapter/connector
(10), first press the air gun release valve (23), then insert the required
adapter into the hose end and release the release valve (23) (Fig D).
Make sure that the adapter is locked in firmly.
3. When connecting the universal adapter (11), screw-on valve
adapter (12) or the deflating adapter (13), these adapters must first
be connected to the nozzle adapter to suit 3-piece nozzle set (8). To
do this, insert the either of the : universal adapter (11), screw-on valve
adapter (12) or the deflating adapter (13), through the rear of the
nozzle adapter to suit 3-piece nozzle set (8) (Fig E). Ensure that the
fitting is secure, then insert the nozzle adapter to suit 3-piece nozzle
set into the hose with valve adapter/connector (10) by pressing the air
gun release valve (23) and inserting into the hose end. Release pressure
on the air gun release valve (23) and ensure the fitting is secure.
To remove the adapter, press down the air gun release valve (23) and
pull the relevant adapter outwards.
Disconnecting the compressure air hose, air gun with pressure
gauge & hose with valve adapter/connector
1. To disconnect the compressed air hose (9) from the quick-lock
coupling (5), pull the sleeve on the quick-lock coupling backwards, and
pull the compressed air hose (9) away from the quick-lock coupling (5).
E
D
1
2
Assembly