J0Z-SP38-1016/90891
AFTER-SALES SERVICE
GB 0845 872 2740
www.coreservice.co.uk
IRL 019022605
Please charge the battery, see section "Start-up".
• The tool is fitted with a quick-clamp drill chuck (1) so that you do not need a drill chuck key
to fit the instrument.
• Change between the two speed settings using the switch (3) for screwing and drilling work.
• Using the torque preselection ring (2) select the appropriate torque for
your work piece
• You can control the direction of rotation using the switch (7). The middle position of this
switch locks the ON / OFF switch (8) and prevents the drill/screwdriver from being switched
on accidentally.
• The drill/screwdriver operates when you push the ON / OFF switch.
• The drill/screwdriver is secured by means of an automatic overload protection. If the tool
is overloaded or the temperature of the battery exceeds 45°C, the overload protection
disconnects the power supply. If the safety shut-down function is activated due to
overheating of the battery, the tool can only be used again when the battery temperature has
been lowered to between 0°C and +45°C.
Note: Spare battery
You can obtain a second battery from our service partner, see guarantee card
(at the end of these instructions).
Unpacking
CAUTION! Danger of suffocation
Keep plastic film and plastic bags away from
babies and infants.
1. Remove the packaging and all protective film.
2. Check the tool including accessories for visible damage. Do not use the tool under
any circumstances if you detect any kind of damage.
Removing the battery (9)
CAUTION! Risk of injury A
If the tool is switched on accidentally, there is a risk of injury.
• When the drill/screwdriver is in idle mode, put the switch
for the direction of rotation (7) in the middle position so that
the ON / OFF switch (8) locks. (Fig. A).
1. To remove the battery (11), press the release button (10)
and pull the battery forwards from the base of the tool.
(Fig. A1)
Charging the battery
The battery must be charged prior to using the tool for the first time.
CAUTION! Damage to the tool
Using the wrong charger may damage the battery.
• Only use the charger (12) supplied to charge the battery
