26
Fault
Cause
Solution
No pressure or only slight
pressure is built up.
There is air in the washer.
Operate the washer
without connecting the
spray gun
11
until the
water is dispensed
without bubbles.
There is no water or an
insufficient supply of water.
Check your water
connection.
Check the water inlet hose
for leaks or blockage.
The dirt filter is clogged.
Clean the dirt filter; see
section “Cleaning the dirt
filter”.
The washer draws in air.
Check for leaks in the water
inlet hose.
Large fluctuations in
pressure
The high-pressure nozzle is
clogged.
Clean the high-pressure
nozzle; see section
“Cleaning the high-
pressure nozzle”.
There is insufficient water
pressure.
Check the water pressure.
The water inlet hose is
kinked.
Check the water inlet hose.
The washer has a leak.
The connections of the
water inlet hose are loose.
Tighten the adapter on the
screw connection for the
water inlet adapter
17
and the screw connection
on your water tap until
hand-tight.
The pump or the internal
connections
have a leak.
Contact the manufacturer
or an authorised service
centre at the service
address specified on the
warranty card.
Troubleshooting
