24v Lithium-ion Cordless Drill with Hammer Action
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. 51887 • 06/2016 • 51887
(toll free)
14
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com
1800 909 909
24v Lithium-ion Cordless Drill with Hammer Action
MODEL: №. 51887 • 06/2016 • 51887
Fitting and removing the battery pack
1. To install the battery pack to the tool, align the
raised portion of the battery pack (6) with the
grooves on the bottom of the drill/driver, and
slide it firmly into the handle until you hear
the battery release button snap into place (Fig A).
2. To remove the battery pack from the tool, press
the battery pack release button (7) and slide the
battery pack comp letely out of tool handle
(Fig B).
When inserting the battery pack into the
charger, make sure the pack is fully seated in the
charger.
To remove the battery pack from the charger
base, press the battery release button and slide
the battery out.
Battery charging
IMPORTANT. Before attempting to charge the battery, check the charger
and the battery to ensure the charging equipment matches the battery
supplied. The components are all labelled with component numbers.
CAUTION! The rechargeable battery is not fully charged on leaving the
factory. Charge the rechargeable battery for approx. 1 hour before first use,
or until fully charged as indicated by the red light going off on the charger.
CAUTION! The working temperature of the charger is 0°C to 45°C.
NOTE: If the battery pack is incorrectly orientated the battery will not fully
enter the base as depicted.
1. Connect the power supply from the charger plug pack (8) to the charger
base (11) via plugging the plug from the charger plug pack into the
charger base housing.
2. Plug in the charger plug pack (8) and switch on at the power supply. The
Green LED power indicator located on the charger base will indicate that
the charger base (11) has power connected to it.
Battery Fitting / Battery Charging
A.
B.
