18
AFTER SALES SUPPORT
www.einhell.co.uk
t
0044 151 649 1500
0044 1890 946 244
IRE
WAC 3050/1
03/2015
Recommended pressure: max. 1–2 bar.
Since it contains oil, condensed water from the oil-lubricated compressor
must not be drained into the sewers or discharged into the environment.
Changing/replenishing oil
The compressor is supplied with the synthetic oil SAE 10W40. All the oil
in the pump system should be replaced after the first 100 hours of opera-
tion.
•
Use an open-end wrench or ring wrench (24 mm) to undo the oil
drain screw (window) on the cover of the crankcase, allow the oil to
drain away completely into a drip tray and reattach the seal.
•
Pour the oil through the oil filler opening in the crankcase and then
reinsert the sealing plug (12), check the oil level in the pump system
every week and replenish with oil as and when required.
Use SAE 10W40 synthetic oil when operating at an ambient temperature
of –5° C to +35° C. The advantage of synthetic oil is that its characteristics
never change in summer or in winter.
The waste oil must not be drained into the sewers or discharged
into the environment.
Take note of the information in the following table for an oil change.
Oil type
Operating hours
Multigrade oils SAE 10W40/15W40
100 or 6 months
Faults
If a fault develops e.g. a part wears out, please contact the service address
stated on the warranty card. These instructions have a detailed overview
of the parts that can be ordered.
WAC_3050_1_EX_GB_SPK7.indb 18
16.10.14 11:34
