Safety
12
d)
Remove any adjusting key or wrench before turning the power
tool on.
A wrench or a key left attached to a rotating part of the pow-
er tool may result in personal injury.
e)
Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situa-
tions.
f)
Dress properly. Do not wear loose clothing or jewellery. Keep
your hair, clothing and gloves away from moving parts.
Loose
clothes, jewellery or long hair can be caught in moving parts.
g)
If dust extractors or collectors can be attached, ensure these are
connected and properly used.
Use of dust collection can reduce
dust-related hazards.
Power tool use and care
a)
Do not force the power tool. Use the correct power tool for your
application.
The correct power tool will do the job better and safer at
the rate for which it was designed.
b)
Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with the switch is danger-
ous and must be repaired.
c)
Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments, chang-
ing accessories, or storing power tools.
Such preventive safety
measures reduce the risk of starting the power tool accidentally.
d)
Store idle power tools out of the reach of children. and do not
allow persons unfamiliar with the power tool or these instruc-
tions to operate the power tool.
Power tools are dangerous in the
hands of untrained users.
e)
Maintain power tools. Check for misalignment or binding of mov-
ing parts, breakage of parts and any other condition that may
affect the power tool’s operation. If damaged, have the power
tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting
tools with sharp cutting edges are less likely to bind and are easier to
control.
Summary of Contents for WB 16-2.0
Page 4: ...4 1 9 16 1 3 A B 1 2 3 4 5 8 6 9 10 7 12 13 11...
Page 5: ...5 1 9 16 1 3 C 1 9 16 1 3 D 7 10 13 6 3 2...
Page 34: ......
