Safety
13
e)
The drill must be rotating before you guide it towards the
workpiece.
Otherwise, the drill can get caught in the workpiece, thus
causing the workpiece to move unexpectedly as well as injuries.
f)
If the drill jams, stop pushing it down and turn off the power
tool. Check and eliminate the cause for it jamming.
Jamming can
lead to the tool moving unexpectedly, causing injury.
g)
Avoid long drill chips by interrupting the downward pressure at
regular intervals.
Sharp metal chips can get caught and lead to injuries.
h)
Never remove drill chips from the area where you are drilling
while the power tool is running. To remove chips, move the drill
away from the workpiece, switch off the power tool and wait
for the drill to stop. Use tools such as a brush or hook to remove
chips.
Contact with turning parts or drill chips can lead to injuries.
i)
The permissible speed of fitted tools with a rated speed must be
at least as high as the maximum speed specified on the power
tool.
Accessories that rotate faster than permissible may break and
be projected.
Safety notes for the line laser
− Do not point the laser beam at persons, animals or reflective surfaces and
do not look into the laser beam yourself. This laser emits a class 2 laser
beam in accordance with DIN EN 60825-1. You could blind people with it.
− A laser is not a toy and does not belong in the hands of children. Using it
incorrectly may result in irreparable damage to the eyes.
− It is forbidden to manipulate the laser so as to increase its power in any
way. No liability will be assumed for any damages caused as the result of
failure to comply with these safety instructions.
− The laser does not contain any serviceable parts. Therefore, do not open
the housing. Otherwise, you will render the warranty void.
−
Warning!
Do not swap the laser with another type of laser. Only the
manufacturer of the laser or an authorised representative may perform repairs.
Safety instructions for batteries
− Attention: Danger of explosion due to improper replacement of the
batteries. Only replace the batteries with the same type or an equivalent
battery type. Observe the “Technical data”.
