Safety
15
− Only open the housing to the extent described in this user manual. Have
qualified professionals perform repairs. Contact a qualified workshop
for this. Liability and warranty claims are waived in the event of repairs
performed by the user, improper connection or incorrect operation.
− Only parts that comply with the original device data may be used for
repairs. Electrical and mechanical parts, which are essential for providing
protection against sources of danger, are located in this drill.
− Protect the drill against moisture and only use it in dry indoor rooms.
− Do not immerse the drill, the mains cord and the mains plug in water or
other liquids.
− Never touch the drill or the mains plug with damp hands.
− Never pull the mains plug out of the socket by the mains cord; instead,
always do so by taking hold of the mains plug.
− Keep the drill, mains plug and mains cord away from open flames and hot
surfaces.
− Lay the power cable so that it does not pose a tripping hazard.
− Do not kink the mains cord and do not lay it over sharp edges.
− Always switch the drill off and pull the mains plug out of the socket when
you are not using the drill, cleaning it, making settings or in the event of a
fault.
− When working with the drill, stand in front of it so that you can easily
operate it and have an eye on everything.
− Only use sharp, undamaged drill bits that are suitable for the respective
material.
− Always use the chip guard when drilling. If applicable, adjust its length for
optimal protection.
− Never touch the chuck or fitted drill bit or tool while it is still rotating. After
you have switched the device off, the clamping chuck will not come to an
immediate stop, but continue to rotate for a while.
− Only use the accessories included in the product contents or those
recommended by the manufacturer.
− Wear suitable work gloves or wait until the drill bit or fitted tool have
cooled off before changing them.
− Do not exert excessive pressure while drilling. Always drill at the speed
that suits the drill bit and the material you are drilling into.
