Instructions
6
IMPORTANT: It must be possible to move the magazine slide without
applying much force. Watch out for jammed staples or nails.
Setting the stapling force (Fig. 1)
You can pre-select the stapling force of the Electric Staple Gun to suit
the length of the staples or nails used and the strength of the material.
To do so, set the stapling force control (3) to the desired force. (Rotate
the wheel clockwise to increase the force, or counter-clockwise to
decrease the force). The ideal stapling force is best determined by
carrying out a trial on a
test piece.
Operation (Fig. 1/5/6)
Before starting your work, always check the filling level indicator (6) to
see if the magazine (5) contains staples or nails and is properly closed
with the magazine slide (4).
Triggering shots
The built-in trigger interlock prevents the Electric Staple Gun from being
triggered accidentally. Triggering is only possible as follows:
•
Push the trigger interlock (2) into the 'ON' position.
•
Press the head of the Electric Staple Gun against the material and
operate the trigger (1).
•
If the Electric Staple Gun is no longer in operation – even for short
periods – push the trigger interlock (2) into the 'OFF' position to
prevent unintentional operation.
Inserting staples
Load the staples into the magazine as shown in Fig. 5.
Inserting nails
Load the nails into the magazine as shown in Fig. 6.
15
14
GB
IRE
WZEN 20
0151 649 1500
1890 946244
www.einhell.co.uk
AFTER SALES SUPPORT
Summary of Contents for WZEN 20
Page 20: ......
