4
Unpacking / Standard Accessories
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop
the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for
any loose, missing or damaged parts. If the hand dryer is damaged or missing
parts, promptly inform the dealer where you purchased it or contact World Dryer
at 1-800-323-0701.
Standard items included with the hand dryer are:
User Manual
Wall Mounting Bracket with
mounting anchors
HEPA Filter Cartridge with Odor
Neutralizing Tablet
Cleaning Brush
Manual
Mounting Template
Installation
CAUTION
Improper mounting could result in personal injury or property damage.
1. Disconnect the power source.
2. Use the mounting template provided to mark the locations for the (4) wall mounting anchors to attach the wall mounting bracket to
the wall.
3. It is recommended that at least 1 of the 4 mounting anchors for the unit be fastened into a wall stud or support.
4. To use the hollow wall anchors included with the wall mounting kit, pre-drill the wall in the marked locations using a 5/16” (8mm)
drill, insert the plastic anchors and tap flush to the wall.
5. Complete the attachment of the wall mounting bracket to the wall with the (4) mounting anchors using a No.
25 torx screwdriver.
6. Remove the small panel at lower rear of hand dryer for accessing the connection terminal block.
7. Connect power supply wiring to terminal block and secure with cable clamp provided.
8. Replace and secure access panel.
NOTE:
This model hand dryer is a double-insulated appliance and does not require an external ground connection.
9. Hang the hand dryer on the bracket. Remove water collection tray from bottom of dryer, and complete the attachment of the dryer
with the 4th anchor.
10. Replace the water collection tray.
11. Connect the power source.
