Step 1
(H-1) KD Bolt M8x20mmx4
Page 3
Step 2
(H-2)
Spring washer M8
x4
(H-3)
Flat (18-8)x1.5mm
x4
Assembly Steps
(B)
Place Top Panel (A) upside down on a padded non-marring surface. Align tabs of Base
(B) to pre-threaded holes on Top Panel (A). Secure using Flat Washers (H-3), Spring
Washers (H-2) and Allen Bolt (H-1), stacking hardware in the order as shown above.
Fully tighten all bolts using Allen Key (T-1).
Stand the table upright, now your table is ready to use.
NOTE: Levelers can be used
for adjustment if needed.
